Top 10 Uses of Aluminum in the Construction Industry
Did you know that 25% of all aluminum is used in the construction industry? In the early twentieth century, aluminum was too expensive and not produced in sufficient volumes to use in…
4 Best Surface Treatment Processes for Aluminum Alloy Die Castings
When it comes to aluminum alloy die castings, the pros and cons of aluminum alloy materials and the process of die casting can affect the appearance of a casting. Aluminum alloy dies…
Extruded Aluminum Profiles vs Die Casting Aluminum Parts
Many people cannot distinguish the process and application of extruded aluminum profiles and diecasting aluminum profiles. This article will introduce the difference between these two processing methods through their respective advantages and characteristics….
Can aluminum be used in the medical industry?
Aluminum is an amazing material that has impacted nearly every major industry over the past century. This includes the medical industry and the many devices we know are transforming healthcare. Today, we’ll…
The Casting of Engine Cylinder Block Aluminum Die Casting Process
Now the lightweight of automobiles has become a trend in automobile manufacturing. Aluminum is a high-performance yet light metal material, so Aluminium Die Casting Parts are the best choice for car engine cylinders. This…
What is the application of aluminum foil tape?
Aluminum foil tape they’re pretty much the same as regular scotch tape. They are both wide and thin profiles, coated with high-strength adhesive on one side, but their main materials are quite different….
How to Install Aluminum Curtain Wall?
The curtain wall aluminum veneer base material adopts 1100H24, 3003H24, 5005H24, and other special single-layer aluminum plates for the curtain wall. As a kind of aluminum curtain wall, aluminum veneer curtain wall has advantages…
Why is Die Cast Aluminum Difficult to Anodize?
The die-casting shell is formed by a mold, so the processing time is short and the cost is relatively low. However, aluminum die casting is difficult to anodize. It is believed that many manufacturers should…
Heat Treatment of Aluminum Die Casting
The metallographic structure of aluminum die casting is coarser than that of deformed aluminum alloy, so it is also different during heat treatment. The former has a long holding time, generally more than…
Why are most stamping parts made of aluminum alloys?
At present, the application of aluminum alloy plates in automobiles has been effectively promoted, from Audi’s all-aluminum body, to Chery Jaguar Land Rover’s partial aluminum body, to NIO’s ES8 all-aluminum body. With…